Rishabh Clamp Power 1000 AC/DC

Product Features

Measures following parameters

• * AC&DC Voltageupto1000V
• * AC&DC Current upto 1000A/400 A
• * Inrush/Peak Value Measurement
• * Active, Reactive and Apparent Power
• * Horse Power Measurement
• * kWh
• * Measure up to49thHarmonics
• * Phase Angle
• * THD
• * DF
• * Power Factor
• * Crest Factor
• * LPF Mode for VFD Application

Unique Design

RISH POWER1000A/400A is a highly Clamp innovative design for features those increases safety and comfort of user.

*  Rotating clamp jaws facilitate the measurement at physically awkward positions, vertical bus bars, conductors placed at positions difficult to access.

*  Clamp jaws can be opened or closed with the trigger placed at bottom side away from the jaws. This allows the user to place his/her hand at safer distance from live conductor. This greatly reduces exposure of human beings to electrical shocks.

*  Location and design of trigger eliminates fatigues caused by single finger operation. It allows spreading the force required to open the jaws over more than one finger to ensure

comfortable operation.

*  Comfortable operation of push buttons and function selector switch, in adverse field conditions.

Large Jaw Opening

Jaw opening of 51mm and 41 mm for standard wire diameter of 50mmand 40mmfor 1000A and 400Arespectively.

Inrush Current Measurement

Clamp meter will be triggered by inrush current >5A. Inrush current for 100msec is measured.

DATA Hold Function

By pressing DATA HOLD button, reading on the display can be latched for Hands free operation.

MIN,MAX Function

By pressing MIN/MAX button, the clamp meter will start recording latest Minimum and Maximum readings

Backlit

It is possible to conduct measurement using the clamp meter during poor light condition with the help of bright white light Backlit.

Non Contact Voltage Detection

The clamp meter can detect the presence of AC Voltage between 100 to 1000 V 50hz/60Hz without any electrical connection and give acoustic signal as an indication.

Three Phase Power Measurement

Clamp meter can measure power in 3 phase 3 wire or 3 phase 4 wire (Symmetric as well as Asymmetric) network without any manual calculation like other clampmeters.

Dual Display

User friendly dual display shows the simultaneous parameters of measuring input quantity.

LPF Mode

LPF mode is available for voltage and current for true measurement of VFD Application

TRMS Measurement

In order to calculate true value of distorted waveform due to presence of high crest factor or harmonics, TRMS measurements is done for AC voltage and current

Auto Power OFF

In order to save the power of the Batteries, the clamp meter will automatically shut OFF if it detects no activity for 10 minutes.

Continuous ON Mode

In this mode, AUTO POWER OFF is disabled.

Low Battery Indication

Double molded Cover for soft touch and firm grip of the Instrument